Startrac 2000/3000 Error Codes
| DISPLAY READS | POSSIBLE CAUSES ARE; |
| CPU ERROR 0, 1 and 2 | •
Power Switch off/on cycled too fast. • Intermittent display cable connection. • Pinched or damaged display cable. • Faulty ground connection. • Low voltage at the M.C.B. or at the CPU. |
| FS ERROR 0 | •
Faulty or damaged display cable. • Faulty ground connection to display board. • Faulty display electronics. |
| FS ERROR 1 | •
Wrong key used when trying to enter Test Mode. • Faceplate keys damaged or shorted. • Low output voltage at the M.C.B. |
| FS ERROR 2 | •
Remote stop switch disconnected. • Remote stop switch shorted, stuck or sticking. • Faulty display board. |
| SPD ERROR 0, 1, and 2 | •
Disconnected or faulty RPM sensor. • Misaligned or rubbing RPM disc. • Flywheel abrading the RPM sensor cable. • Dirty RPM sensor and disc. • RPM out of calibration. • Faulty display cable, display board, or M.C.B. • Worn motor brushes. • Faulty drive motor. • Flywheel rubbing on the shroud. |
| EL ERROR 0 | •
0% switch failed, disconnected or stalled. • 0% switch sticking or contaminated. |
| EL ERROR 1 and 3 | •
Faulty M.C.B. • Open circuit in the elevation system. • Blown elevation fuses. • Faulty elevation motor. • Worn elevation motor brushes. • Misaligned or faulty elevation sensor. • Faulty limit switches. • Mechanical binding. |
| EL ERROR 2 | •
Excessive coasting after running elevation. • Faulty M.C.B. |
